Emulsions
Various products in different types to ultimately fit the required purposes
Special formulas for enhanced efficiency
Special fillers, additives, and modified polymers for optimum performance
G500
A premium-quality putty made of acrylic copolymer with special additives for High performance on Wall and
wood substrates.
G500
– Excellent with sand ability.
– Ease of Application on wood substrates.
– Excellent ability to fill porous surfaces and small holes..etc.
– Long Open time for application and Crack free on high thickness.
– Provides very smooth layer on Exterior and Interior Application.
(Complies with The Saudi Standards (SASO) 2107/2019))
G500
All surfaces (new and old) should be clean and free from dust, oil, fat, ..etc.
FOR NEW CEMENTITIOUS SURFACES:
– Concrete Sealer
– 2 – 3 coats Perbuild G500
FOR WOOD SURFACES
– Apply the Putty directly on Wood or after adding an Oil undercoat.
FOR OLD SURFACES:
– Use sandpaper, then clean the surface with water and suitable detergent. Make sure the surface is fully dry,
then apply 1 or 2 coats of Perbuild G500
S99
An attractive matt emulsion paint based on modified Acrylic copolymer to provide a smooth finish and good
appearance.
S99
– Excellent Whiteness.
– High resistance to water and alkali.
– High Adhesion Power.
– Less odor.
– High Wet hiding power and Good Spreading Rate.
(Complies with The Saudi Arabia Standards (SASO) GSO-2582))
S99
All the new and old substrates should be cleaned properly to make them free from dirt, grease, oil, wax, etc.
FOR NEW SURFACES
– Apply of 1 coat of concrete Sealer
– Apply of 2-3 coats of Perbuild G500
– Apply of 2 coats of Perbuild S99
FOR OLD SURFACES
– After complete removal of loosely held materials, wash the substrate thoroughly with detergent and water.
– Make sure the surface is fully dry and soft then apply • 1-2 Coats of Perbuild S99
CONDITIONS OF APPLICATION
– Temperature of surface to be painted should not be lower than 10°C and 3°C above dew point. Appropriate
air temperature and humidity should be observed.